Dascom 7010 PrintServer Manual - Manual (Page 162)

Maintenance
Print Server User Manual 162
Dynamic Update via the PRINTSERVER-NetTool
Specify a directory on the file server for automatic (dynamic)
updates. The directory contains the current software files.
Requirements
;
The file server on which the software files are stored either uses
the 'anonymous login' or the print server is set up as 'user' on
the file server.
Proceed as follows:
1. Start the PRINTSERVER-NetTool.
2. Select a print server from the print server list.
3. Select Actions – Firmware Update - Dynamic Update from the
menu bar. The Dynamic Updatedialog appears.
4. Tick Dynamic Firmware Update.
5. Specify the IP address of the file server on which the new
software files are to be stored.
Syntax:
ftp:///
Example: ftp://192.168.0.100/a-fw-ps-12.bin
(If your system supports name resolution via WINS, DHCP, or DNS, you can enter
the name of the file server instead of the IP address of the file server).
Example: ftp://file.server.de/a-fw-ps-12.bin
6. If you use a proxy server, tick Use proxy server and enter the IP
address of the proxy server.
7. Click OK to confirm.
ª
The settings are saved. At each restart, the print server verifies
the version of the software files. If the print server detects a
higher version, this version will be installed automatically on the
print server.
Dynamic Update via FTP
The parameters for a dynamic update can also be configured via FTP.
For further information, read section ’Configuring Parameters via an
FTP Connection’
Ц
34.