Dascom 7010 PrintServer Manual - Manual (Page 182)

Additional Features
Print Server User Manual 182
Configuring the Logical Printers
You can adapt the assigned functions and printer ports to your
needs.
Proceed as follows:
1. Start the PRINTSERVER Homepage or start the
PRINTSERVER-NetTool and double-click the print server in the
print server list.
2. Select Configuration – Logical Printer.
3. Change the desired parameters, see: Table 21
Ö
182.
4. Click Save or OK to confirm.
ª
The setting is saved.
Table 21: Settings of the Logical Printers
Parameters Description
Start Sequences /
End Sequences Depending on the application, you might have to configure the
logical printer. These sequences may consist of PRESCRIBE or
ESC commands. ESC commands consist of job start sequence
'\027' followed by the actual control characters preceded by a
backslash and written as a decimal. Job end sequence '\027 \012',
for example, triggers a form feed after the print job. For more
information, please look up the available ESC commands in your
printer manual.
Search/
Replace Using 'Find' and 'Replace,' you can look for strings in the data sent
to the print server and replace them with new strings. Wildcards
and truncations cannot be used. The string can consist of max.
256 characters.
Hex dump mode Enables/disables the hex dump mode. The hex dump mode is
mainly used to search for errors in print data. The hex dump mode
displays each character both as hexadecimal code and ASCII
character code. Printer control commands are printed as
hexadecimal values and do not influence the printout in any way.
CR + LF Enables/disables the conversion from line feed (LF) to carriage
return with line feed (LF+CR).
Banner page Enables/disables the printing of a banner page when the LPD
protocol is used.
Banner page mode Defines the format in which the banner page will be printed.
(ASCII)