Dascom 7010 PrintServer Manual - Manual (Page 71)

Device Settings of the Print Server
Print Server User Manual 71
6.4 How to Adapt the Network Speed
Three modes of transmission between two equal nodes provide for
network communication: simplex, half duplex, and duplex.
Duplex Mode The print server is able to recognize the duplex mode used in a ether
network and to adapt to it automatically. This happens via
autonegotiation (also: autosensing). The print server recognizes the
network speed and the duplex mode of the network port to which it
is attached and configures its own parameters accordingly.
This 'Auto' mode is preset. In addition, users can also configure the
duplex mode manually.
If you set the speed manually, the speed must correspond to the
speed of the other network components. It is not possible to
operate the print server with full duplex if the hub functions with
half duplex, for example.
What do you want
to do?
†
’Adapting the Speed via the PRINTSERVER Homepage’
Ö
71
†
’Adapting the Speed via the PRINTSERVER-NetTool’
Ö
71
Adapting the Speed via the PRINTSERVER Homepage
Proceed as follows:
1. Start the PRINTSERVER Homepage.
2. Select Configuration – General.
3. Select the desired setting from the Ethernet settings list.
4. Click Save to confirm.
ª
The setting is saved.
Adapting the Speed via the PRINTSERVER-NetTool
Proceed as follows:
1. Start the PRINTSERVER-NetTool.