3 how to reset parameters to their default values, How to reset parameters to their default values – Dascom 7010 PrintServer Manual User Manual
Page 152
Maintenance
Print Server User Manual
152
14.3 How to Reset Parameters to their Default Values
You can reset all print server parameters to their default values
(factory default settings). Earlier settings will be deleted in this
process. Installed certificates will not be deleted.
Since the IP address of the print server will be reset as well, the
PRINTSERVER Homepage cannot be started or displayed after the
reset.
You must reset the parameters, for example, if you want to use the
print server in another network by changing the location of the
printer. Before this change of location, you should reset the
parameters to the default settings to install the print server in
another network.
If a password has been set in the print server, the password has to be
entered before resetting the parameters. No password is necessary if
you reset the print server using the status button of the print server
operating panel.
What do you want
to do?
’Resetting Parameters via the PRINTSERVER Homepage’
’Resetting Parameters via the PRINTSERVER-NetTool’
’Resetting Parameters via an FTP Connection’