Dascom 7010 PrintServer Manual - Manual (Page 154)

Maintenance
Print Server User Manual 154
Resetting Parameters using the Status Button
The reset process comprises three different steps.
• In the first step, the print server is forced into reset mode. The
parameters are reset in this mode.
• The second step involves restarting the printer or the print
server.
• In the third step, a status page is printed. The status page can be
used to check whether the parameters were successfully reset.
(Note: It is not possible to print a status page via a GDI printer.)
IMPORTANT: The reset mode is signaled by the simultaneous
flashing of the Activity LED (yellow) and the Status LED (green)
and remains active for the duration of five flashes.
The status button must be released within this time frame,
otherwise the print server will go into BIOS mode. In this case you
need to start the reset process again.
These three steps are illustrated in the following. Internal and
external print server models each have their own processes, which
are illustrated separately. The illustrations may vary slightly from
your device model.
Before starting the reset process, disconnect the network cable from
the print server in order to avoid the distracting flashing Link LED.
(Does not apply to WLAN print server models.)