Dascom 7010 PrintServer Manual - Manual (Page 116)

Internet Protocol Security (IPsec)
Print Server User Manual 116
11.1 How to Create IPsec Rules
This section describes the creation of IPsec rules via the input mask
of the Print Server Homepage.
Rule Structure
IPsec rules are composed of filters and actions.
Filter A filter must be defined to check the data traffic. The filter consists
of the following elements:
• Local IP address
The local IP address corresponds to the IP address of the print
server. The existing IPv4 address of the print server will be used
and cannot be changed at this point. IPv6 addresses can be
defined via an address template.
• Remote IP address
Addresses in the format IPv4 and IPv6 are supported. You can
also specify IP address ranges. IP addresses and ranges can be
stored in address templates and added to a rule.
• Services
Specifies the services that are used by an IP data packet. A
service includes the protocol to be used and its port. Several
protocols can be summarized in one service template and stored
using a freely definable name.
Action An action determines the measure to be taken if an IP data packet
corresponds to the description of a filter. The following actions can
be selected:
• Allow all (allow IP data packets)
• Drop all (block IP data packets)
• Use IPsec (forward IP data packets via an SA)