Dascom 7010 PrintServer Manual - Manual (Page 64)

Print Server Status Information
Print Server User Manual 64
Fig. 16: PRINTSERVER-NetTool – Print Server in BIOS Mode
Troubleshooting The software must be loaded on the print server so that the print
server can switch from the BIOS mode to the normal mode.
Proceed as follows:
1. Start the PRINTSERVER-NetTool.
2. Select the print server from the print server list.
(You will find the print server under 'BIOS Mode’.)
3. Select Installation – IP Wizard from the menu bar.
The IP Wizard is started.
4. Follow the instructions of the wizard in order to assign an IP
address to the print server.
The IP address is saved.
5. Do a software update on the print server; see: ’How to Perform
an Update’
Ö
157.
ª
The software is saved in the print server. The print server
switches to the normal mode.