Creating ipsec rules, Enabling ipsec rules, Defining address templates – Dascom 7010 PrintServer Manual User Manual
Page 120
Internet Protocol Security (IPsec)
Print Server User Manual
120
Creating IPsec Rules
IP data packets can be filtered by address and log information and
be assigned to an action. The assignment of filters and filter actions
is done via rules.
Proceed as follows:
1. Start the PRINTSERVER Homepage.
2. Select Configuration – IPsec.
3. Select Edit rules.
4. Define the filters.
To do this, mark the templates to be used in the ’Address filter’
and ’Service filter’ lists.
5. Mark the filter action to be used in the ’Action’ list.
6. If you have chosen the ’Require IPsec’ filter action you must
also mark the ’Secutity Association (SA)’ to be used.
7. Click Save.
ª
The settings are saved.
Enabling IPsec Rules
An IPsec policy is composed of several rules. The rules to be used
must be enabled so that they can be taken into consideration within
the IPsec policy. The activity is controlled by means of the check
boxes on the left side of the rules.
Afterwards you must enable the entire IPsec policy for the rules to
take effect; see:
Defining Address Templates
Local and remote IP addresses can be defined in the address
template. Addresses in the format IPv4 and IPv6 are supported.
3 address templates has been implemented by default. You can
specify another 5 templates, if required.
The IPv4 address of the print server is always used as the local IPv4
address. The address is not shown in the template.