Dascom 7010 PrintServer Manual - Manual (Page 229)

Appendix - Parameter List
Print Server User Manual 229
Table 36: Parameter List - Protection
nf_pop3_user
[User name] max. 255 characters Defines the name used by the print server
to log on to the POP3 server.
nf_pop3_pwd
[Password] max. 255 characters Defines the password the print server uses
to log on to the POP3 server.
nf_pop3_secure
[Security] 0 = off (no security)
1 = APOP
2 = SSL Defines an authentication method.
nf_pop3_mdel
[Delete read
messages] on/off Enables/disables the automatic deletion of
read emails on the server.
nf_pop3_limit
[Ignore mail
exceeding] max. 4 characters; [0-9]
0-9999
0 = unlimited Defines the maximum email size (in kbyte)
to be accepted by the print server.
Parameters Value Description
passwd
[Password] max. 16 characters Defines the password for the authorization
to change print server parameters.
If a password was set, you must enter the
password before you can save the
changes to the parameters.
access_control
[Access control] on/off Enables/disables the password demand
for print server parameters.
This parameter only makes sense if a
password was set at an earlier stage; see
above.
ip1_sender
~
ip8_sender
[IP sender] max. 255 characters Defines the IP address or host name of the
client that is authorized to address the
print server in the network.
Once an IP sender has been defined, all
undefined clients lose their authorization.
Up to eight IP senders can be specified.
The use of wildcards (*) is possible to
authorize subnetworks, for example.
Parameters Value Description