ACU-RITE CNC 3500i - Manual (Page 325)

ACU-RITE 3500i 299
1
0
.1 CAM Pr
ogr
a
mming
Setup tab:
 Tool: Once the tool has been entered into the tool table, its tool
number can be entered here.
 Feed: The tool feed rate is entered here. This is automatically
calculated if tool being used is defined in the Tool Table.
 Coolant: Choose None, On (M8), Off (M9), or Mist (M7). See
"Coolant" on page 292.
 Spindle Dir: Choose Forward, Reverse, Off or None. See "Spindle
Direction" on page 292.
 Spindle Speed: Specify spindle speed. See "Spindle Speed" on page
292.
Bolt Hole tab:
The Bolt Hole tab must have the appropriate data filled in to use the
Bolt Hole option in the Drill Location selection.
 Diameter: The diameter of bolt hole circle pattern can be entered
here.
 # Holes: The number of holes in the pattern are entered in this field.
 Start Angle: The starting angle of the pattern is entered in this field.
 Path: Choose the machine movement required: Linear, or Radial.
 X Center: Location of the center of rotation in the X axis.
 Y Center: Location of the center of rotation in the Y-axis.
 End Angle: The end angle of the last hole.
 Index Angle: This is the angle to rotate the Polar Coordinate
System by.