ACU-RITE CNC 3500i - Manual (Page 138)

112 6 Conversational Editing
6.1 Con
v
ersational Pr
ogr
a
mming
Deleting a program block:
There are two ways to delete program blocks from a Program Listing.
The following provide the steps necessary to delete a block, or blocks.
 In Edit Mode, place the cursor at the beginning of the
first block to be deleted. Touch the Delete Block
button to delete one block at a time.
The Cut button can also be used.
 Touch the Edit Features button to access the next
menu.
 Touch the Cut button to remove the block, or blocks
selected and place them on the clipboard.
 If removing more than one block at a time is desired,
first use one of the Mark methods described in “Mark
a program block”. Highlight multiple blocks, then
press the Cut button to remove them.
Inserting a program block:
Inserting a program block (or blocks) in an existing program is typically
done by adding a feature at the correct location in the program.
 Place the cursor where a new block is to be inserted.
 Add the feature that is required at that location. See "Conversational
Data Input Cycles" on page 105 which provides a list of features
available.