ACU-RITE CNC 3500i - Manual (Page 237)

ACU-RITE 3500i 211
7.
3 Pr
obing Cy
cles
Field Code Description
OvrSlw
Feed S This is the override for the slow feedrate
that was set in the machine setup
parameter ZFirstPickFeedRate_Slow. This
is used for the same reason as the M cycle
parameter. This can only be set slower.
Trying to set this higher will result in the
software using the original feedrate.
(Optional)
OvrRPM R This is the override for the RPM that was
set in the machine setup parameter
calibAndToolMeasurementRPM. This is
used for the same reason as the M cycle
parameter. This can only be set slower.
Trying to set this higher will result in the
software using the original RPM. If you
would like the cycle to run without the
spindle turning, enter a negative value in
the "R" parameter. (Optional)