Avaya Cajun P882 - Manual (Page 248)

9-24
Chapter 9
Cajun P550/P880/P882 Switch User Guide
2. Refer to Table 9-6 to configure the IP Static Route dialog box
parameters:
3. Click CREATE to save your changes, or CANCEL to restore
previous settings.
Creating IP
Static Routes
Using the CLI To create IP static routes using the CLI in configure mode:
cajun(configure)# ip route-preference
Refer to the Cajun™ P550™/P880/P882 Command Line Interface
Reference Guide for Version 5.0 for details about this command.
Creating IP Static ARP Entries
You can create static ARP entries on the switch using the web agent
or the CLI.
Creating IP
Static ARP
Entries Using
the Web Agent To create a static ARP entry in your switch’s ARP cache using the
web agent:
1. Select Static ARP from the Routing > IP > Configuration
group on the web agent window. The IP Static ARP Entries
dialog box opens (Figure 9-9).
Table 9-6. IP Static Route Parameters
Parameter Allows you to...
Network Address Enter an IP network address for your IP static route.
Mask Enter an IP subnet mask for your IP static route.
Next-Hop Address Enter an IP address for the gateway associated with
the IP static route.
Next-Hop Interface Enter an interface that is associated with the IP static
route.
Cost Enter the metric between this router and the
destination.
Note: The metric you enter overrides routing
protocol metrics.
Preference Select a low or high routing preference from the
Preference field pull-down menu.