Avaya Cajun P882 - Manual (Page 192)

5-40
Chapter 5
Cajun P550/P880/P882 Switch User Guide
Configuring
Fast Start Mode
Using the CLI To configure Fast Start mode for ports on a module associated with a
selected bridge using the CLI, enter the following command from
Configure mode:
> (configure)# set port fast-start
Refer to the Cajun P500/P880/P882 Switch Command Line Interface
Reference Guide for more details about this command.
Using the All Module Ports Configuration Window
The All Ports Configuration window allows you to apply the same
parameter settings to all switch ports in a module using a single
command.
To set all switch ports in a module using a single command:
1. Select Configuration from the Modules & Ports group on the
web agent window. The Module Information dialog box
opens (Figure 5-12).
2. Select the checkbox in the Slot column next to the module on
which you want to configure all of its ports.
3. Select the number in the Ports column for that module. The
Physical Port Configuration dialog box for that module opens
(Figure 5-14).