Allied Telesis AT-WA7501 User Manual
Page 74

Chapter 3: Configuring the Ethernet Network
74
4. Click Submit Changes to save your changes. DHCP Server Setup
appears in the menu.
5. From the menu, click DHCP Server Setup. The DHCP Server Setup
screen appears.
6. Configure the DHCP server. For help, see the next table.
7. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 45.
Table 4. DHCP Server Setup Parameter Descriptions
Parameter
Explanation
Low Address
Enter the low IP address in the range of IP
addresses available to the DHCP server for
distribution to DHCP clients.
If these addresses are not on the same subnet as
the access point, the access point will perform
Network Address Translation (NAT) for the clients
to which it grants IP addresses.