Allied Telesis AT-WA7501 - Manual (Page 282)

Chapter 9: Additional Access Point Features
282
where:
f is the program name.
s is the optional segment location of the program.
Example:
To run program UAPBOOT.PRG from the flash memory segment, enter:
FFR UAPBOOT.PRG 1
FI
Purpose:
Reinitializes the access point file system. If the access point file system or
a file segment becomes corrupt, use this command to reset it.
Syntax:
FI ( s )
where s is the optional number of the segment to be reinitialized. You can
use any segment number (1, 2, 3, or 4) to specify the one flash memory
segment on the access point.
FX
Purpose:
Downloads a file using Ymodem batch protocol into the flash segment that
is specified by s.
Syntax:
FX s
where s is destination segment. You can use any segment number (1, 2,
3, or 4) to specify the one flash memory segment on the access point.
HDW
Purpose:
Loads the FPGA configuration file into the access point. If you are directed
to change the FPGA firmware in the access point, use this command.
Syntax:
HDW f ( s )