Allied Telesis AT-WA7501 - Manual (Page 30)

Chapter 1: Getting Started
30
Example - Configuring an 802.11b WAP With Roaming End Devices
In this example, there is one 802.11b radio in the access point and there
are two 802.11b radios (802.11b Radio-1 and 802.11b Radio-2) in the
WAP. Wireless end devices can roam between the WAP and the access
point.
Figure 11. 802.11b WAP with Roaming End Devices
You need to configure the wireless end devices to have the same SSID,
LAN ID, and frequency as the WAP master radio (802.11b Radio-1). You
do not need to configure any secondary LAN settings because the WAP is
not connected to a secondary LAN.
Allied Telesyn recommends that you always implement some type of
security.
Table 7. 802.11b Access Point and WAP Parameter Settings
Screen Parameter
Access
Point
802.11b
WAP
802.11b
Radio-1
WAP
802.11b
Radio-2
802.11b
Radio Allow
Wireless
Access
Points On Primary (not
applicable)
Node Type Master Master Station
SSID ATILAN ATILAN ATILAN
Spanning
Tree
Settings LAN ID 11 11 11
Root
Priority 5 0 (not
applicable)
Ethernet
Bridging
Enabled Checked Checked (not
applicable)
Ethernet
Access
point
Host
WAP