beautypg.com

Allied Telesis AT-WA7501 User Manual

Page 275

background image

AT-WA7500 and AT-WA7501 Installation and User’s Guide

275

You can also set the baud rate to autobaud, which lets the access point
set its baud rate to match the baud rate of your wireless end device. Type
SR 0 and press Enter twice.

Using Content

Addressable

Memory (CAM)

Mode Commands

You may need to use CAM commands to perform certain functions. Since
the Ethernet port on the access points supports data rates significantly
higher than the radio ports, all frames cannot be forwarded from the
Ethernet network to the radios. CAM, which is controlled by the Field
Programmable Gate Array (FPGA), filters frames based on the radio’s
capability.

Because the commands can cause undesirable results if not properly
executed, you should contact Technical Support for assistance if you are
unsure about the proper procedure to use.

To enter CAM mode

1. Type CAM and press Enter.

2. Enter a password. The default password is EV98203C (case

sensitive).

When you are in CAM mode, the CAM prompt (CAM>) appears.

To exit CAM mode

ˆ

At the CAM prompt, type X and press Enter.

You return to the ap prompt.

This manual is related to the following products: