Allied Telesis AT-WA7501 - Manual (Page 276)

Chapter 9: Additional Access Point Features
276
To display CAM commands
ˆ Type any letter or number other than B and press Enter. The CAM
commands appear on the screen.
Using Test Mode
Commands
Within the AP monitor, Test mode lets you perform certain test functions.
Because the commands can cause undesirable results if not properly
executed, you should contact Technical Support for assistance if you are
unsure about the proper procedure to use.
To enter Test mode
1. Type TEST and press Enter.
2. Enter a password. The default password is EV98203T (case
sensitive).
When you are in Test mode, the test prompt (test>) appears.
To exit Test mode
ˆ At the test prompt, type X and press Enter.
You return the ap prompt.