Allied Telesis AT-WA7501 - Manual (Page 109)

AT-WA7500 and AT-WA7501 Installation and User’s Guide
109
You can use this feature to form a secure wireless hop. Clear all check
boxes, except for the Allow IAPP check box.
Or you may want to use this feature in a terminal emulation environment
when you know the end devices are sending only UDP Plus or Wireless
Transport Protocol (WTP) frames. Check the Allow UDP Plus check box or
the Allow Wireless Transport Protocol check box and clear all other check
boxes (except the Allow IAPP check box). The access point master radio
will only accept the UDP Plus or WTP frames and discard all other frames,
which can make a more secure network.
Note
If any of the devices are also DHCP clients, you need to check the
Allow DHCP check box.
To configure 802.11g radio inbound filters
1. From the main menu, click 802.11g Radio > Advanced Configuration >
Inbound Filters (Primary Only). The Inbound Filters screen appears.
2. For each frame type, check or clear each check box. For help, see the
next table.
3. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 45.