Allied Telesis AT-WA7501 - Manual (Page 110)

Chapter 4: Configuring the Radios
110
Applying Hot
Settings
You can “hot set” the Power Output Level and Mixed Mode Performance
parameters for the 802.11g radio, which means that the new settings can
be immediately activated without rebooting the access point.
To apply hot settings
1. From the main menu, click 802.11g Radio > Advanced Configuration
and change the parameters as needed.
2. Click Submit Changes to save your changes to the “current”
configuration file (as defined in “Saving Configuration Changes” on
page 45).
Table 4. 802.11g Radio Inbound Filter Descriptions
Parameter Description
Allow IAPP Determines if this radio accepts IAPP (Inter
Access Point Protocol) frames from other access
point station radios. The IAPP frames must match
Ethernet protocol 875c.
Allow Wireless
Transport Protocol
(WTP) Determines if this radio accepts WTP frames
from end devices. The WTP frames must match
Ethernet protocol 875b.
Allow UDP Plus
(UDP/IP Port 5555) Determines if this radio accepts UDP Plus frames
from end devices. The UDP Plus frames must
match the UDP network port 5555 on the DCS
30X, Allied Telesyn Gateway, or ARP.
Allow DHCP Determines if this radio accepts DHCP frames.
The DHCP frames must match UDP destination
port 67 and ARP. Check this check box if the end
devices are DHCP clients.
Allow All Other
Protocols Determines if this radio accepts all other
protocols that are not filtered by one of the filters
in this screen.