Allied Telesis AT-WA7501 - Manual (Page 291)

AT-WA7500 and AT-WA7501 Installation and User’s Guide
291
TFTP SERVER LOG
Purpose:
The access point can function as a TFTP server. You can use the TFTP
server log command to save a history of TFTP client requests. The TFTP
server log contains useful TFTP server status information. The log begins
when you set up the server. To clear the log, reboot the access point.
Syntax:
TFTP SERVER LOG
TFTP SERVER START
Purpose:
Use this command to enable the access point to act as a server. You can
enable one access point to act as a TFTP server and download files to
additional access points.
Syntax:
TFTP SERVER START access
where access is blank for read-only access (default), or rw for read/write
access. TFTP does not require any authentication, so a read/write TFTP
server is very insecure and should be used only briefly. When the access
point boots, read-only access is restored.
After you issue this command, the access point responds to TFTP client
requests that are directed to its IP address. When acting as a server, the
access point supports up to four concurrent TFTP sessions.
TFTP SERVER STOP
Purpose:
When you are done transferring files, you can stop the access point from
being a TFTP server by using this command.
Invalid opcode during put This error should not occur under normal
operating conditions. This error indicates
a TFTP protocol error that will not occur
when you use TFTP servers that conform
to the protocol.
Error Message Explanation