Allied Telesis AT-WA7501 User Manual
Page 31

AT-WA7500 and AT-WA7501 Installation and User’s Guide
31
Example - Configuring an 802.11a WAP With Roaming End Devices
In this example, there is one 802.11a radio in the access point and there is
one 802.11a radio in the WAP. Wireless end devices can roam between
the WAP and the access point.
Figure 12. 802.11a WAP with Roaming End Devices
You need to configure the wireless end devices to have the same SSID,
LAN ID, and frequency as the WAP radio. You do not need to configure
any secondary LAN settings because the WAP is not connected to a
secondary LAN.
Allied Telesyn recommends that you always implement some type of
security.
Table 8. 802.11a Access Point and WAP Parameter Settings
Screen
Parameter
Access
Point
802.11a
WAP
802.11a
802.11a
Radio
Allow Wireless Access
Points
On Primary
Node Type
Master
Master
SSID
ATILAN
ATILAN
Spanning
Tree
Settings
LAN ID
11
11
Root Priority
5
0
Ethernet Bridging Enabled
Checked
Checked
Secondary LAN Bridge
Priority
0
0
Ethernet
Access
point
Host
WAP