Allied Telesis AT-WA7501 - Manual (Page 118)

Chapter 4: Configuring the Radios
118
3. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 45.
Table 7. 802.11b Radio Inbound Filter Descriptions
Parameter Description
Allow IAPP Determines if this radio accepts IAPP (Inter
Access Point Protocol) frames from other access
point station radios. The IAPP frames must match
Ethernet protocol 875c.
Allow Wireless
Transport Protocol
(WTP) Determines if this radio accepts WTP frames
from end devices. The WTP frames must match
Ethernet protocol 875b.
Allow SpectraLink
Voice Protocol
(SVP) Determines if this radio accepts SVP frames from
voice wireless telephones. The SVP frames must
match IP 119.
Allow UDP Plus
(UDP/IP Port 5555) Determines if this radio accepts UDP Plus frames
from end devices. The UDP Plus frames must
match the UDP network port 5555 on the DCS
30X, Allied Telesyn Gateway, or ARP.
Allow DHCP Determines if this radio accepts DHCP frames.
The DHCP frames must match UDP destination
port 67 and ARP. Check this check box if the end
devices are DHCP clients.
Allow All Other
Protocols Determines if this radio accepts all other
protocols that are not filtered by one of the filters
in this screen.