Allied Telesis AT-WA7501 - Manual (Page 148)

Chapter 5: Configuring the Spanning Tree
148
Configuring IP Tunnels
For guidelines, see “About IP Tunnels” on page 140.
To configure the IP Tunnels screen
1. From the main menu, click IP Tunnels. The IP Tunnels screen
appears.
2. Configure the IP tunnels parameters. For help, see the next table.
3. Click Submit Changes to save your changes. To activate your
changes, from the menu bar click Save/Discard Changes, and then
click Save Changes and Reboot. For help, see “Saving Configuration
Changes” on page 45.
Table 3. IP Tunnel Parameter Descriptions
Parameter Explanation
Mode Choose the mode:
Originate if Root: Lets the root access point and
root candidates originate the IP tunnel if they are
functioning as the root access point for the
network.
Listen: Configures access points that are
designated bridges or designated bridge
candidates for their remote IP subnets to serve as
the endpoint of an IP tunnel.
Disabled: Disables the IP tunnel port.