Allied Telesis AT-S62 - Manual (Page 95)

AT-S62 Command Line User’s Guide
95
SET SNMP COMMUNITY
Syntax
set snmp community=”community”
[access=read|write] [open=yes|no]
Parameters
community Specifies the SNMP community string whose access
level or access status is to be changed. This
community string must already exist on the switch.
This parameter is case sensitive. The name must be
enclosed in double quotes if it contains a space or
special character, such as an exclamation point.
Otherwise, the quotes are optional.
access Specifies the new access level. Options are “read” for
read only access and “write” for both read and write
access. If no access level is specified, the default is
“read.”
open Specifies the open or closed access status of the
community string. The options are:
yes The community string is open, meaning that
any management workstation can use the
string to access the switch.
no The community string is closed, meaning that
only those management workstations whose
IP addresses are assigned to the string can use
it to access the switch. To add IP addresses of
management workstations to a community
string, refer to ADD SNMP COMMUNITY on
page 81. The default setting for a community
string is closed.
Description
This command changes the access level or access status of an existing
SNMP community string.
Examples
The following command changes the access status for the SNMP
community string “sw44” to closed:
set snmp community=sw44 open=no