Allied Telesis AT-S62 - Manual (Page 268)

Chapter 17: Event Log and Syslog Server Commands
268
DISABLE LOG OUTPUT
Syntax
disable log output[=id_number]
Parameters
output Specifies the ID number of the syslog server
definition to disable. The range is 2 to 20. You can
specify only one ID number at a time. Omitting an ID
number disables all syslog server definitions.
Description
This command disables the specified syslog server definition and stops
the switch from sending any further system events to the defined server.
To permanently remove a syslog server definition, see “DESTROY LOG
OUTPUT” on page 266. To enable the syslog server definition again, see
“ENABLE LOG OUTPUT” on page 270.
Examples
The following command disables (but does not delete) the syslog server
definition with the ID number 7:
disable log output=7
The following command disables all syslog server definitions:
disable log output