Allied Telesis AT-S62 - Manual (Page 93)

AT-S62 Command Line User’s Guide
93
ENABLE SNMP AUTHENTICATETRAP
Syntax
enable snmp authenticatetrap|authenticate_trap
Parameters
None.
Description
This command configures the switch to send authentication failure traps
to trap receivers. The switch sends an authentication failure trap
whenever a SNMP management station attempts to access the switch
using an incorrect or invalid community string, or the management
station’s IP address has not been added to a community string that has a
closed access status.
The default setting for sending authentication failure traps is disabled.
Refer to ADD SNMP COMMUNITY on page 81 to enter the IP addresses of
the SNMP trap receivers.
The AUTHENTICATETRAP and AUTHENTICATE_TRAP keywords are
equivalent.
Example
The following command configures the switch to send authentication
failure traps to SNMP trap receivers:
enable snmp authenticatetrap