Allied Telesis AT-S62 - Manual (Page 199)

AT-S62 Command Line User’s Guide
199
SHOW IP ARP
Syntax
show ip arp
Parameters
None
Description
This command displays the IP addresses in the ARP table. It includes the
following fields:
Interface
The network interface of a table entry. The switch has two
network interfaces. The “loopback” designation represents the
interface used by the switch for internal diagnostics. The “eth0”
designation represents the Ethernet network interface.
IP Address and
MAC Address
The IP addresses and their corresponding MAC addresses.
Type
The type of ARP entry. An entry can be permanent, meaning it can
never be deleted from the table, or temporary. Only the “loopback”
entry is permanent. All “eth0” entries are temporary.
Example
The following command displays the ARP table.
show ip arp