Allied Telesis AT-S62 - Manual (Page 39)

AT-S62 Command Line User’s Guide
39
DISABLE IP REMOTEASSIGN
Syntax
disable ip remoteassign
Parameters
None.
Description
This command deactivates the DHCP and BOOTP client software on the
switch. This command is equivalent to DISABLE DHCPBOOTP on page
38. The default setting for the client software is disabled.
To activate the DHCP and BOOTP client software, refer to ENABLE DHCP
on page 42, ENABLE BOOTP on page 41, ENABLE IP REMOTEASSIGN on
page 43, or SET IP INTERFACE on page 55.
Example
The following command deactivates the DHCP and BOOTP client
software:
disable ip remoteassign