Allied Telesis AT-S62 - Manual (Page 209)

AT-S62 Command Line User’s Guide
209
DELETE LACP PORT
Syntax
delete lacp port=port [aggregator=name]
Parameters
port Specifies the port to delete from an aggregator. You
can delete more than one port at a time. You can
specify the ports individually (for example, 5,7,22), as a
range (for example, 18-20), or both (for example, 1,14-
16).
aggregator Specifies the name of the aggregator. The name is
case-sensitive. This parameter is optional.
Description
This command removes a port from an aggregator. You do not have to
include the name of the aggregator in the command. If the port is not a
member of an aggregator, this error message is displayed:
ERROR CODE = CLI_AGGREGATOR_KEY_DOES_NOT_EXIST
To completely remove an aggregator, see DESTROY LACP AGGREGATOR
on page 210.
Caution
Disconnect the network cable from a port before removing it from
an aggregator. Removing a port without first disconnecting the
cable can result in loops in your network topology, which can result
in broadcast storms and poor network performance.
Example
The following command removes port 9 from its current aggregator
assignment:
delete lacp port=9