Allied Telesis AT-S62 - Manual (Page 221)

AT-S62 Command Line User’s Guide
221
SET SWITCH PORT MIRROR
Syntax
set switch port=port mirror=none|rx|tx|both
Parameters
port Specifies the source ports of a port mirror. You can
specify more than one port. You can specify the ports
individually (for example, 5, 7, 22), as a range (for
example, 18-23), or both (for example, 1, 5, 14-22).
mirror Specifies which traffic on the source ports is to be
mirrored to the destination port. The options are:
rx Specifies ingress mirroring.
tx Specifies egress mirroring.
both Specifies both ingress and egress
mirroring.
none Removes a port as a source port.
Description
This command specifies the source ports of a port mirror. If the port
mirror already has source ports, the new source ports are added to the
existing ports. You can also use the command to remove source ports.
You must set the destination port before you can select the source ports.
To set the destination port, refer to SET SWITCH MIRROR on page 220.
Example
The following command specifies ports 16 and 17 as new source ports
for the port mirror. Only the ingress traffic is mirrored:
set switch port=16-17 mirror=rx
The following command removes ports 5, 7, and 10 as source ports of a
port mirror:
set switch port=5,7,10 mirror=none