Allied Telesis AT-S62 - Manual (Page 218)

Chapter 12: LACP Commands
218
SHOW LACP
Syntax
show lacp [port=port|all] [aggregator=name]
[machine=port|all]
Parameter
port Specifies the port(s) to display. You can specify the
ports individually (for example, 5,7,22), as a range (for
example, 18-20), or both (for example, 1,14-16).
aggregator Specifies the name of the aggregator. The name is
case-sensitive.
machine Specifies the LACP machine state for a port or ports on
the system.
Description
This command displays the configuration and/or machine states of the
ports, and/or the aggregators.
Examples
The following command displays general LACP status information:
show lacp
The following command displays the LACP configuration for ports 13
and 16:
show lacp port=13,16
The following command displays the configuration of the aggregators
on the system:
show lacp aggregator
The following command displays the LACP machine states for each port
on the system:
show lacp machine