Allied Telesis AT-S62 - Manual (Page 48)

Chapter 4: Basic Switch Commands
48
PURGE IP
Syntax
purge ip [ipaddress] [netmask] [route]
Parameters
ipaddress Returns the switch’s IP address to the default setting
0.0.0.0.
netmask Returns the subnet mask to the default setting
0.0.0.0.
route Returns the gateway address to the default setting
0.0.0.0.
Description
This command returns the switch’s IP address, subnet mask, and default
gateway address to the default settings. This command is similar in
function to the RESET IP command. Where they differ is that this
command allows you to specify which parameter to reset, while the
RESET IP command automatically resets all three parameters.
To set these parameters, refer to SET IP INTERFACE on page 55 and SET IP
ROUTE on page 57. To view the current settings, refer to SET SYSTEM on
page 61.
Examples
The following command returns the IP address and subnet mask to the
default values:
purge ip ipaddress netmask
The following command resets just the gateway address to its default
value:
purge ip ipaddress route
The following command resets all three parameters:
purge ip