Allied Telesis AT-S62 - Manual (Page 38)

Chapter 4: Basic Switch Commands
38
DISABLE DHCPBOOTP
Syntax
disable dhcpbootp
Parameters
None.
Description
This command deactivates the DHCP and BOOTP client software on the
switch. This command is equivalent to DISABLE IP REMOTEASSIGN on
page 39. The default setting for the client software is disabled.
To activate the DHCP and BOOTP client software, refer to ENABLE DHCP
on page 42, ENABLE BOOTP on page 41, ENABLE IP REMOTEASSIGN on
page 43, or SET IP INTERFACE on page 55.
Example
The following command deactivates the DHCP and BOOTP client
software:
disable dhcpbootp