Allied Telesis AT-S62 - Manual (Page 279)

AT-S62 Command Line User’s Guide
279
Description
This command displays the entries stored in the switch’s event log.
An event log can display entries in two modes: normal and full. In the
normal mode, a log displays the time, module, severity, and description
for each entry. In the full mode, a log also displays the filename, line
number, and event ID. If you want to view the entries in the full mode,
use the FULL parameter. To view entries in the normal mode, omit the
parameter.
The MODULE parameter displays entries generated by a particular
AT-S62 module. You can specify more than one module at a time. If you
omit this parameter, the log displays the entries for all the modules.
Table 4 lists the modules and their abbreviations.
Table 4 AT-S62 Modules
Module Name Description
ALL All modules
ACL Port access control list
CFG Switch configuration
CLASSIFIER Classifiers used by ACL and QoS
CLI Command line interface commands
DOS Denial of service defense
ENCO Encryption keys
ESTACK Enhanced stacking
EVTLOG Event log
FILE File system
GARP GARP GVRP
HTTP Web server
IGMPSNOOP IGMP snooping
IP System IP configuration, DHCP, and BOOTP
LACP Link Aggregation Control Protocol
MAC MAC address table