Allied Telesis AT-S62 - Manual (Page 118)

Chapter 7: SNMPv3 Commands
118
CREATE SNMPV3 TARGETADDR
Syntax
create snmpv3 targetaddr=targetaddr params=params
ipaddress=ipaddress udpport=udpport
timeout=timeout retries=retries taglist=taglist
[storagetype=volatile|nonvolatile]
Parameters
targetaddr Specifies the name of the SNMP manager, or host, that
manages the SNMP activity on the switch, up to 32
alphanumeric characters.
params Specifies the target parameters name, up to 32
alphanumeric characters.
ipaddress Specifies the IP address of the host.
udpport Specifies the UDP port in the range of 0 to 65535. The
default UDP port is 162. This is an optional parameter.
timeout Specifies the timeout value in milliseconds. The range
is 0 to 2,147,483,647 milliseconds, and the default is
1500 milliseconds. This is an optional parameter.
retries Specifies the number of times the switch resends an
inform message. The default is 3. This is an optional
parameter.
taglist Specifies a tag or list of tags, up to 256 alphanumeric
characters. Use a space to separate entries. This is an
optional parameter.
storagetype Specifies the storage type of this table entry. This is an
optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.
Description
This command creates an SNMPv3 Target Address Table entry.