Allied Telesis AT-S62 - Manual (Page 491)

AT-S62 Command Line User’s Guide
491
SET RADIUSACCOUNTING
Syntax
set radiusaccounting [status=enabled|disabled]
[serverport=value] [type=network]
[trigger=start_stop|stop_only]
[updateenable=enabled|disabled] [interval=value]
Parameters
status Activates and deactivate RADIUS accounting on the
switch. Options are:
enabled Activates RADIUS accounting. This
option is equivalent to the ENABLE
RADIUSACCOUNTING command.
disabled Deactivates the feature. This is the
default. This option is equivalent to the
DISABLE RADIUSACCOUNTING
command.
serverport Specifies the UDP port for RADIUS accounting. The
default is port 1813.
type Specifies the type of RADIUS accounting. The default
is Network. This value cannot be changed.
trigger Specifies the action that causes the switch to send
accounting information to the RADIUS server. The
options are:
start_stop The switch sends accounting
information whenever a client logs on or
logs off the network. This is the default.
stop_only The switch sends accounting
information only when a client logs off.
updateenable Specifies whether the switch is to send interim
accounting updates to the RADIUS server. The
default is disabled. If you enable this feature, use the
INTERVAL parameter to specify the intervals at
which the switch is to send the accounting updates.