Allied Telesis AT-S62 - Manual (Page 308)

Chapter 20: Quality of Service (QoS) Commands
308
ADD QOS FLOWGROUP
Syntax
add qos flowgroup=integer classifierlist=integers
Parameter
flowgroup Specifies the ID number of the flow group you want
to modify. You can modify only one flow group at a
time.
classifierlist Specifies the new classifiers for the flow group. The
new classifiers are added to any classifiers already
assigned to the flow group. Separate multiple
classifiers with commas (e.g., 4,11,12).
Description
This command adds classifiers to an existing flow group. The classifiers
must already exist. Any classifiers already assigned to the flow group are
retained by the group. If you want to add classifiers while removing the
those already assigned, refer to SET QOS FLOWGROUP on page 330.
Example
This command adds the classifiers 4 and 7 to flow group 12:
add qos flowgroup=12 classifierlist=4,7