Allied Telesis AT-S62 - Manual (Page 217)

AT-S62 Command Line User’s Guide
217
SET LACP STATE
Syntax
set lacp state=enable|disable
Parameters
state Specifies the state of LACP on the switch. The options are:
enable Enables LACP. This option performs the same
function as ENABLE LACP on page 212.
disable Disables LACP. This is the default. This option
performs the same function as DISABLE LACP
on page 211.
Description
This command enables or disables LACP on the switch.
Caution
Do not disable LACP if there are defined aggregators without first
disconnecting all cables connected to the aggregate trunk ports.
Otherwise, a network loop might occur, resulting in a broadcast
storm and poor network performance.
Example
The following command enables LACP on the system:
set lacp state=enable