Allied Telesis AT-S62 - Manual (Page 161)

AT-S62 Command Line User’s Guide
161
DISABLE SWITCH PORT FLOW
Syntax
disable switch port=port flow=pause
Parameter
port Specifies the port where you want to deactivate flow
control. You can specify more than one port at a time.
You can specify the ports individually (for example,
5,7,22), as a range (for example, 18-23), or both (for
example, 1,5,14-22).
Description
This command deactivates flow control on a port. Flow control applies
only to ports operating in full duplex mode. This command performs the
same function as the FLOWCONTROL parameter in the SET SWITCH
PORT command.
Example
This command deactivates flow control on port 6:
disable switch port=6 flow=pause