Allied Telesis AT-S62 - Manual (Page 425)

AT-S62 Command Line User’s Guide
425
edgeport Defines whether the port is functioning as an edge
port. An edge port is connected to a device
operating at half-duplex mode and is not
connected to any device running STP or MSTP.
Selections are:
yes, on, true The port is an edge port. These
values are equivalent. This is the
default.
no, off, false The port is not an edge port.
These values are equivalent.
ptp Defines whether the port is functioning as a point-
pointtopoint to-point port. This type of port is connected to a
device operating at full-duplex mode. Selections
are:
yes, on, true The port is an point-to-point
port.
no, off, false The port is not an point-to-point
port.
autoupdate The port’s status is determined
automatically. This is the default.
migrationcheck This parameter resets a MSTP port, allowing it to
send MSTP BPDUs. When a MSTP bridge receives
STP BPDUs on an MSTP port, the port transmits STP
BPDUs. The MSTP port continues to transmit STP
BPDUs indefinitely. Set the migrationcheck
parameter to yes to reset the MSTP port to transmit
MSTP BPDUs.
yes, on, true Enable migration check. The
values are equivalent.
no, off, false Disable migration check. The
values are equivalent.
100 Mbps 20,000
1000 Mbps 2,000
Table 12 Auto External Path Trunk Costs
Port Speed Port Cost