Allied Telesis AT-S62 - Manual (Page 71)

AT-S62 Command Line User’s Guide
71
ADD SNTPSERVER PEER|IPADDRESS
Syntax
add sntpserver peer|ipaddress=ipaddress
Parameter
peer Specifies the IP address of an SNTP server. These
ipaddress parameters are equivalent.
Description
This command adds the IP address of an SNTP server to the SNTP client
software on the switch. The switch uses the SNTP server to set its date
and time. If an IP address has already been assigned, the new address
overwrites the old address. To view the current SNTP client settings,
refer to SHOW SNTP on page 78.
Note
If the switch is obtaining its IP address and subnet mask from a
DHCP sever, you can configure the DHCP server to provide the
switch with an IP address of an NTP or SNTP server. If you configured
the DHCP server to provide this address, then you do not need to
enter it with this command.
Example
The following command specifies the IP address of 148.35.16.248 for the
SNTP server:
add sntpserver ipaddress=148.35.16.248