Allied Telesis AT-S62 - Manual (Page 200)

Chapter 11: Networking Stack Commands
200
SHOW IP ROUTE
Syntax
show ip route
Parameter
None
Description
This command displays the IP route table. It includes the following fields:
Destination
The IP address of a destination network, subnetwork, or end node.
Mask
A filter used to designate the active part of the destination IP
address. A binary 1 in the mask indicates an active bit in the
address while a binary 0 indicates that the corresponding bit in
the address is not.
Next Hop
The IP address of the next intermediary device to reaching the
destination network, subnetwork, or end node.
Interface
The interface on the switch where the next hop is located. The
switch has two interfaces. The interface “loopback” is for internal
diagnostics only. The other interface is “eth0.”
Example
The following command displays the IP route table:
show ip route