Allied Telesis AT-S62 - Manual (Page 275)

AT-S62 Command Line User’s Guide
275
SET LOG OUTPUT
Syntax
set log output=id_number [destination=syslog}
[server=ipaddress]
[facility=default|local1|local2|local3|local4|
local5|local6|local7]
[syslogformat=extended|normal]
[module=all|module]
[severity=all|severity-list]
Parameters
output Specifies the ID number of the syslog server
definition to be modified. The range is 2 to 20.
destination Specifies the destination for the log messages. The
only option currently supported is:
syslog Forwards log messages in syslog format
to a syslog server.
server Specifies a new IP address for the syslog server
definition.
facility Specifies a new syslog facility level for the events.
default Adds a facility level based on the
functional groupings defined in the RFC
3164 standard. The codes applicable to
the AT-S62 management software and
its modules are shown in Table 2 on
page 264. This is the default setting.
local1 to local7
Adds a set facility code of 17 (LOCAL1)
to 23 (LOCAL7) to all event messages.
For a list of the levels and their
corresponding codes, refer to Table 3
on page 265.