Allied Telesis AT-S62 - Manual (Page 347)

AT-S62 Command Line User’s Guide
347
SET QOS COSP
Syntax
set qos cosp=priority-number qid=queue-number
Parameters
cosp Specifies the Class of Service (CoS) priority level. The
CoS priority levels are 0 through 7, with 0 as the
lowest priority and 7 as the highest. You can assign
more than one priority to an egress queue.
qid Specifies the egress queue number. The egress
queues are numbered 0 through 3, with queue 0 as
the lowest priority and 3 as the highest. You can
specify only one egress queue.
Description
This command maps CoS priorities to port egress queues. You must
specify both the priority and the queue ID. You can assign more than
one priority to an egress queue. Table 6 on page 345 lists the default
mappings between the eight CoS priority levels and the four egress
queues of a switch port.
Note
This command is equivalent to MAP QOS COSP on page 345.
Example
The following command maps priorities 5 and 6, to egress queue 1:
set qos cosp=5,6 qid=1