Allied Telesis AT-S62 - Manual (Page 205)

AT-S62 Command Line User’s Guide
205
ADD LACP PORT
Syntax
add lacp port=port aggregator=name|adminkey=key
priority=priority
Parameters
port Specifies the port to be added to the aggregator. You
can add more than one port at a time. You can specify
the ports individually (for example, 5,7,22), as a range
(for example, 18-20), or both (for example, 1,14-16).
aggregator Specifies the name of the aggregator. The name is
case-sensitive.
adminkey Specifies the adminkey of the aggregator. This is a
hexadecimal number in the range 0x1 to 0xffff.
priority Specifies the priority level of the port. This is a
hexadecimal number in the range 0x1 to 0xffff. The
lower the number, the higher the priority. The default
is the port number in hexadecimal. For instance, the
default priority level for port 10 is 0x000A.
Description
This command adds ports to an existing aggregator. You can set a port’s
priority value when you add it to an aggregator. You can identify the
aggregator by its name or adminkey number. To create an aggregator,
refer to CREATE LACP AGGREGATOR on page 207.
Caution
A network cable should not be connected to a port on the switch
until after the port is added to the aggregator. Connecting the cable
before the port is a part of an aggregator can result in loops in your
network topology, which can result in broadcast storms and poor
network performance.
Note
Before adding a port to an aggregator, verify that the port’s speed is
set to Auto-Negotiation or 100 Mbps, full-duplex. Aggregate trunks
do not support half-duplex mode.