Allied Telesis AT-S62 - Manual (Page 355)

AT-S62 Command Line User’s Guide
355
SET POE THRESHOLD
Syntax
set poe threshold=value
Parameters
threshold Specifies the threshold as a percentage of the total
amount of PoE available. The range is 1 to 100.
Description
The PoE threshold sends an SNMP trap to your management
workstation and enters an event in the event log when the total power
requirements of the powered devices exceeds the specified percentage
of the total maximum power available on the switch. At the default
setting of 95%, the switch sends an SNMP trap when the PoE devices
require more than 380 W, which is 95% of 400 W, the maximum available
power on the AT-8524POE switch. The threshold is adjustable. Of course,
for your management workstations to receive traps from the switch, you
must configure SNMP on the switch by specifying the IP addresses of the
workstations.
Examples
The following command sets the threshold to 80% of the available
power:
set poe threshold=80