Allied Telesis AT-S62 - Manual (Page 54)

Chapter 4: Basic Switch Commands
54
SET ASYN
Syntax
set asyn speed=1200|2400|4800|9600|19200|38400|
57600|115200 [prompt=”prompt”
]
Parameter
speed Sets the speed of the RS-232 terminal port on the
switch. The default is 9600 bps.
prompt Specifies the command line prompt. The prompt
can be from one to 12 alphanumeric characters.
Spaces and special characters are allowed. The
prompt must be enclosed in double quotes. This
parameter performs the same function as the
command SET PROMPT on page 27.
Description
This command sets the baud rate of the RS-232 terminal port on the
switch. The port is used for local management of the switch. This
command can also be used to set the command line prompt.
Note
A change to the baud rate of the port will end your management
session if you are managing the switch locally. To reestablish a local
management session you must change the speed of the terminal or
the terminal emulator program to match the new speed of the
RS-232 terminal port on the switch.
Example
This example sets the baud rate to 115200 bps:
set asyn speed=115200