Allied Telesis AT-S62 - Manual (Page 51)

AT-S62 Command Line User’s Guide
51
RESTART REBOOT
Syntax
restart reboot
Parameters
None.
Description
This command resets the switch. The switch runs its internal diagnostics,
loads the AT-S62 management software, and configures its parameter
settings using the current boot configuration file. The reset will takes
approximately 20 to 30 seconds to complete. The unit does not forward
traffic during the time required to run its internal diagnostics and
initialize its operating software. Some network traffic may be lost.
Caution
Be sure to use the SAVE CONFIGURATION command to save your
changes before resetting the switch. Any unsaved changes will be
discarded.
Your local or remote management session with the switch ends when
the unit is reset. You must reestablish the session to continue managing
the unit.
Example
The following command resets the switch:
restart reboot